Nobody wants to deal with toilet problems but as a homeowner, you will eventually face it at a certain point. The best course of action would be to call a plumber for plumbing repair. However, you could also do some troubleshooting of your own. To help ease your worries, provided below are some toilet repair tips you need to know.
Plumbing tips you need to know about repairing broken toilets
You might sometimes hear your toilet start to spontaneously refill as if somebody had flushed it. A toilet that will cut on and then off by itself, or runs intermittently on its own, has an issue that is referred to as a phantom flush. The issue is nearly certainly due to a bad flapper or perhaps a flapper seat. You can fix this by draining the tank and the bowl, inspect and clean up the flapper seal, and change the flapper when it is damaged or worn out. If you can’t seem to figure out the cause of the problem after a few attempts, you might want to call in a professional for Florence plumbing repair.
Water Trickles Into The Tank
If you can hear your toilet producing a sustained hissing sound, it might be due to water trickling into the tank through the supply line. If that’s the case, then you have to check the float, refill tube, as well as the ballcock or the inlet-valve assembly. The hissing sound is generally caused by water that is coming through the inlet valve. The first thing you need to check is if the float requires some adjustment or if it is sticking. Then, inspect to ensure that the refill tube is not inserted too far into the overflow tube. If these adjustments do not solve the issue then you might have to change the ballcock assembly installed by a plumber.
The Bowl Empties Slowly
A weak flush or a bowl that empties slowly is usually caused by clogged holes underneath the rim of the bowl. You can use the curved part of the wire to poke each flush hole gently to get rid of any debris. You can also use coat hangers and a tiny mirror to help you see underneath the rim. You may also use the wire to loosen debris that might be obstructing the siphon jet at the bottom of the drain. Just be sure that you don’t scratch the bowl.
The most common toilet problem is the dreaded clog. One quick plumbing tip is that you can clear a clog using various tools. Among the most effective ones is a force cup plunger. It works better than the typical type of getting rid of the clog. Insert the bulb into the drain and then pump forcefully. Release the handle slowly, let a little water in so you could see if the drain has been cleared out. Repeat the process if required. For serious obstructions, you can use a closet auger. Insert the auger’s end into the drain hole and then twist its handle while pushing the rotor downward. Don’t forget to avoid scratching the bowl.
According to Plumbing Experts Florence, a typical toilet has a minimum of five seals with a possibility of leaking. In every case, the quick fix is to determine the defective seal and replace or tighten it. The biggest seal is the one located between the bowl and the tank. A major plumbing leak will happen if there’s a break in this spot. If you change this seal, it requires draining and the removal of the tank.
Call Plumbing Experts Florence if you need help with your toilet problems. You may reach us at (843) 536-4568 for a free estimate.
Plumbing Experts Florence
Florence, SC 29501